The track is mounted under the ceiling or to the wall.
The sliding door is suspended in the top track via its top track rollers.
The sliding doors then travel in the top track freely suspended over the floor.
The system is balanced by a 13 mm height difference between the floor and ceiling.
The guide pin is attached to the floor.
The drilling depth is minimum (30 mm), so it is possible to also use the system in the presence of underfloor heating.
The sliding doors are guided at the bottom via the guide pin.
The sliding doors travel between the top track and the floor rail.
Specially developed stops in the floor rail and track allow the sliding door to be individually positioned.
This system can automatically accommodate any differences in height of up to 15 mm.
Ceiling or wall mounting is possible.
The sliding door is guided at the top in the ceiling track and travels along the floor rail via two bottom track rollers.
The weight of the sliding door does not place any load on the ceiling or the wall.
This system is also suitable for sloping ceilings.
You can choose the floor rail to match your floor covering (fitted carpet, parquet, stone etc.).
A floor rail is available for retrofitting. It features a special double-sided adhesive tape that adheres to the floor (it is possible to remove this rail at a later date without damaging the floor).
The inova sliding door system, gliding quietly and effortlessly
The sealing profile on the frame (with multiple leaf arrangements) ensures that the door leaves always close tightly and quietly irrespective of whether the suspension or floor rail system is used.
